Indesit IWME 147, Инструкция по эксплуатации, Страница: 6 / 20

6
GB
Instructions for the fitter
Mounting the wooden panel onto the door and in-
serting the machine into cabinets:
In the case where the machine must be shipped for final
installation after the wooden panel has been mounted, we
suggest leaving it in its original packaging. The packaging
was designed to make it possible to mount the wooden
panel onto the machine without removing it completely
(see
figures below).
The wooden panel that covers the face of the machine must
not be less than
18 mm in thickness and can be hinged on
either the right or left. For the sake of practicality when using
the machine, we recommend that the panel be hinged on
the same side as the door for the machine itself - the left.
A B
C
D
E
Door Mounting Accessories (Fig. 1-2-3-4-5).
Fig. 1
N° 2 Hinges
N° 1 Magnet N° 1 Magnet plate
N° 1 Rubber plug
N° 2 Hinge Supports
N° 4 Spacers
Fig. 2
Fig. 3 Fig. 4
Fig. 5
Fig. 4/B
- No. 6 type A self-threading screws, l =13 mm.
- No. 2 type B metric, countersunk screws, l =25; for faste-
ning the magnet plate to the cabinet.
- No. 4 type
C
metric screws, l =15 mm; for mounting the
hinge supports to the cabinet.
- No. 4 type
D metric screws, l =7 mm; for mounting the
hinges on the supports.
Mounting the Parts onto the Face of the Machine.
- Fit the hinge supports to the appliance front panel, positio-
ning the hole marked with an arrow in
fig. 1 so that it is on the
inner side of the front panel. Fit a spacer ( fig. 4/B) between
the surfaces using type C screws.
- Fit the magnet plate at the top of the opposite side, using
type
B screws to fix two spacers (fig. 4/B) between the plate
and the surface.
Tur se
ite