Indesit HD 79, Инструкция по установке и эксплуатации

Страница: 17 / 60

17
External exhausting version
To utilize this function you have to provide with
a flexible duct Ø150 mm. to connect to the fitting
"
F " ( Diagram 2) , that must be subsequently fixed
to the ceiling.
Operation with recirculated air
When there is no exhaust duct for venting outdoors,
you can use a carbon filter. The air is depurated by
the filter and put again in the surrounding. To use
the appliance in this version, proceded as follows:
-
Fix the filtering fitting " D " to the bracket " E "
( Diagram 2 ).
- Insert the ring " A " to the filtering fitting " D ".
- Insert a flexible duct from the fitting " F " to the
ring " A " and fix it with some small bands.
- Open the grate;
- Insert the filter " C " using the “ B ” knobs
( Diagram 6 );
- Remount the grate;
- To convert the hood from “External exhausting
version” to “recirculated air,” contact the
retailer or the manufacturer for the kit needed
for installation.
Installing the chimney
- Fasten the “ E ” bracket ( Diagram 2 ), located
on the perpendicular part of the outlet hole on the hood, at the highest point on the wall
next to the ceiling, using the two Ø 8 mm screws and wall anchors provided.
- Make the chimney with slits run inside the other chimney
- Fix the chimney with slits turned up to the bracket " E " using the two screws supplied with
the hood; put the other chimney on the upper part of the hood and fix it using the 2 screws
supplied with the hood.
A
E
D
F
D.150
Diagram 2