GB
9
Starting and selecting a programme
1.
Plug the dryer into the power supply socket.
2.
Select the programme according to the type of laundry
(see Laundry).
3.
Open the door, ensure that the filter is clean and securely placed
.
4.
Load the machine, making sure that no piece of laundry gets between the door and the door seal. Close the door.
5.
Press the ON/OFF button to start the machine.
6.
After consulting the programme chart and the indications for each type of fabric (
see Laundry
), turn the Programme selection knob
to the programme corresponding to the type of laundry to be dried
(see Programmes and options).
!
Warning: If the position of the programme selection knob changes after pressing the START/PAUSE button, the selected
programme will NOT be modified. To modify the programme, press the START/PAUSE button to put the programme in pause mode
(the indicator light flashes orange), then select a new programme and the relative options. Press the START/PAUSE button to start
the new programme.
7.
If required, set the time of the delayed start and any other options
(see Programmes and options).
8.
Press the START/PAUSE button to start the drying cycle.
Laundry can be checked while the drying programme runs and any garments already dry can be removed, while drying continues
for the remaining items. After closing the door, press the START/PAUSE button to resume machine operation.
9.
The final COOL TUMBLE phase (i.e. the fabrics are cooled) activates during the last few minutes of the drying programme; always
allow this phase to terminate.
10.
When the
END
indicator light turns on, the programme has ended.The buzzer will beep 3 times to let you know that your
programme is complete. Open the door, remove the laundry then clean the filter and replace it.
If the “Post anti-crease” option was selected and laundry is not removed immediately, the drum will rotate garments at intervals for
10 hours or until the door is opened.
11.
Disconnect the dryer from the power supply.
Standby mode
This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled
after about 30 minutes if no activity is detected. Press and hold the
ON/OFF
button until the dryer reactivates.
How to carry out a
drying cycle
