AU
3
Connecting the water outlet hose
Connect the outlet hose (without bending it) to a drain duct with
a minimum diameter of 4 cm. Alternatively, rest it over a sink
or tub; the free end of the hose should not remain immersed in
water.
The specialist plastic elbow*
makes it easier to
fi
nd the best
layout:
fi
x the elbow to the wall
securely in order to prevent the
outlet hose from moving and
spilling the dirty water.
The part of the hose marked
with the letter A should be
between 40 and 100 cm above
the ground
(see
fi
gure)
.
We advise against the use of hose extensions.
Electrical connection
Before inserting the plug into the electrical socket, make sure
that:
The socket is earthed and complies with current regulations.
The socket can withstand the maximum load of the appli-
ance, which is indicated on the data plate located on the
inside of the door
(see chapter entitled Description of the
appliance).
The power supply voltage falls within the values indicated on
the data plate on the inside of the door.
The socket is compatible with the plug of the appliance. If
this is not the case, ask an authorised technician to replace
the plug
(see Assistance);
do not use extension cables or
multiple sockets.
Once the appliance has been installed, the power supply
cable and the electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must be replaced
by the manufacturer or its Technical Assistance Service in order
to prevent all potential hazards. (See Assistance)
The Company shall not be held responsible for any
incidents that occur if these regulations are not observed.
Anti-condensation strip*
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order to
protect it from any condensation which may form.
Advice regarding the
fi
rst wash cycle
After the appliance has been installed, immediately before
running the
fi
rst wash cycle, completely
fi
ll the salt dispenser
with water and add only then approximately 1 kg of salt
(see
chapter entitled Rinse aid and re
fi
ned salt)
. The water may
over
fl
ow: this is normal and is not a cause for concern. Select
the water hardness value
(see chapter entitled Rinse aid and
re
fi
ned salt)
. – After the salt has been poured into the machine,
the LOW SALT indicator light* switches off.
If the salt container is not
fi
lled, the water softener and the
heating element may be damaged as a result.
A
Technical Data
Dimensions
width 60 cm
height 85 cm
depth 60cm
Capacity
14 standard place settings
Water supply
pressure
0.05 - 1 MPa (0.5-10 bar)
7.25-145 psi
Power supply
voltage
See appliance data plate
Total absorbed
power
See appliance data plate
Fuse
See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/CE dated 16/01/2007 (Low
Voltage) and subsequent modi
fi
ca-
tions
-89/336/EEC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent modi
fi
cations
-97/17/EC (Labelling)
-2002/96/ CE Waste Electrical and
Electronic Equipment (WEEE)
* Only available in selected models.
