HYDRAULIC PRESSURE TEST PUMP
FEATURES :
The Test Pump is very compact, light in weight and can be unbolted to carry easily.
Stand is designed in such a way to keep on plane surface and operate without any foundation. Even
in high pressure Pumps also no fixing or foundation is needed. All the working parts are made of
stainless steel to stand the specified pressure. All the joints are threaded so that any part can be
easily replaced even at site also.
Prod.
No.
231D
Capacity
(Bars)
140 Kg. / Cm²/14MPa
Tank Cap.
(Ltrs. APX)
10
Tank Cap.
(Ltrs.)
8
Suction
Cap.
25 CC
Wt.
(Kgs.)
17.000
Unit Conversion :
1MPa = 10Bar = 10.1972kg/Cm²/ = 145.038Psi
Page # 2- M:231B/D/E/F/G
2
4
3
1
5
6
7
9
8
10
11
12
13
15
14
16
Page # 1- M:231B/D/E/F/G
Pressure 140Kg/cm2
Height
27"
Width
12"
Weight
17Kgs
The following instruction will help in the smooth operation of the pump :
1. Fill the rank with the clean water only. If dust or other foreign particles through the water enter
into the valves, which will cause pressure dropping.
2. Before starting operation, the pressure release valve should be kept open and water should
be allowed to drain out for a few strokes, then close the valve and build the required
pressure. This is to remove air, or else constant pressure cannot be developed.
3. Maximum length of the stroke can used while beginning and should be progressively
reduced when the pressure developed.
4. If the check valve found disturbed and pump fail to develop pressure, the valve seat should
be cleaned or lapped if necessary.
5. Suitable lubrication oil should be used to lubricate the plunger and ensure smooth
operation.
6. While keeping the pump idle, apply, lubricant oil and insert the piston fully in the cylinder so
that water contents will not remain inside the pump and shall be
free of being rusty.
HOW TO OPERATE
HYDRAULIC PRESSURE TEST PUMP
S. No. Description
PART DIAGRAM AND LIST
S. No. Description
1. PLUNGER
2. PUMP BODY
3. LN BOLT 8X40 (4PC)
4. DELIVERY VALVE
PLUG
5. DISTRIBUTOR
6. RELIEF VALVE
RETURN DELIVERY
7. PRESSURE GAUGE
8. SPOTTER
9. LN BOLT 8X45 M8
10. BRACKET
11. HANDLE
12. PVC GRIP
13. STAND
14. HOSE PIPE
½ BSP
15. SECTION PIPE
16. TANK
