FLYINGBAR
38
FLYINGBAR_05-06-2020
SET TIME
OFF
TIME
ON 1
TIME
ON 2
After installing the battery, the display will show the following picture for 5 seconds.
The display then shows the current hour. if no button is pressed during the following 8 seconds,
the words will disappear on the display until another button is pressed.
If you press the buttons P1, P2 or P3, the display will show the pre-set programmes as in the fol-
lowing images. Attention: the programmes P1-P2 and P3 are pre-set and cannot be changed.
The programme P4 allows the user to set two refrigerator working cycles (the first cycle Time on1
–Time off1 and the second cycle Time on2 and Time off2).
To customise the programme P4:
press P1 and P4 simultaneously.
“Time On1” will start to flash on the left.
Use the buttons - (P2) and + (P3) to set the starting time of the first cycle.
Press the button P1 to move ahead to the following fields and then use the - and + buttons again
to change the starting and stopping time of the operation cycles of the compressor.
After completing the customisation of the programme, press P4 to save the new settings.
NOTE: After having used the minibar with the TIMER operation method, to pass again in STAN-
DARD operation method, please set P4 on the remote control with all value at 00:00 and push P4
(see instruction SETTING THE TIME).
NOTE: After having used the minibar with the SMART operation method, to pass again in STAN-
DARD operation method, unplug the SIGNAL cable and st P4 on the remote control with a value
at 00.00 and push P4 (see instruction SETTING THE TIME).
