HFL-500-E/HFL-600-
E User’s Manual
Page 6 of 24
IL-HFL-500/600-E UM
Copyright 2022 IndeeLift Inc. All Rights Reserved
04/07/2022
Preparing the HFL for use:
Unpacking the HFL:
The HFL comes packaged for shipment in a carton. Packed inside a box in the shipping carton will be the
battery charger, two batteries and two sets of safety belt assemblies.
1)
Remove the box cap and sides.
2)
Roll the unit onto the floor.
3)
Deploy the outriggers and seat as described in Steps 1 - 4 on page 7.
4)
Install the battery pack as described in Step 5, below.
5)
Test the unit by raising and lowering the seat using the up/down rocker switch.
Charging the Battery Pack
It is recommended that the HFL
’s battery pack
be fully charged prior to its first use in
the field.
1.
Attach the male end of the charger power supply
’s input power cord to any standard 110/120 VAC
grounded wall power outlet.
2.
Remove the battery pack from the HFL by pressing inward on the two black push-button retention
releases while lifting the battery pack from the device.
3.
Place the battery pack in the charger and allow approximately one hour for the battery to fully
charge.
Note: The battery pack, charger and the HFL are all keyed so the battery pack cannot be
installed into the charger or the HFL incorrectly.
4.
After approximately one hour, remove the battery pack from the charger.
NOTE: The LED indicator
glows green when the battery is fully charged.
5.
Install the battery into the HFL, ensuring the retention releases snap the battery into place
.
NOTE: HFL-500/600-E machines are shipped with
two
batteries and a charger
. This enables the HFL’s
battery to be swapped out at weekly intervals, or as described in the department
’
s standard
operating procedure for portable tools that utilize rechargeable batteries.
