6
-1
1
0
2
3
4
5
11
13
14
15
16
17
18
19
12
10
6
0
2
3
4
5
1
9
11
12
13
14
15
16
10
8
Fig. 14
Moving to any new scale setting
First:
Unlock carriage clamp
Second:
Slide fence as you view scale
through hairline cursor
Third:
Return clamp to
upright “locked”
position
OPERATION
8
Moving to a New
Scale Setting
Moving the fence to any new scale
setting is just as easy as moving any
other fence youʼve used before. Push
the carriage clamp down to unlock the
carriage, then slide the fence as you
sight through the hairline cursor.
When you see your measurement
under the hairline, pull the clamp back
up to the locked position, Fig. 14.
Remember that the INCRA TWIN will
only clamp every
1
/
32
", so donʼt try to
clamp in between scale marks. It just
wonʼt work!
Although the clamping
pressure has been factory
adjusted, you may wish to
fine-tune the pressure to suit
your individual needs. If so, use
the thin plastic shims provided
and follow the instructions
shown on page 18.
CAUTION: For your safety, keep
your hands behind the fence
when moving to any new scale
position.
For more information on using
INCRA tools on the router table,
table saw and drill press,
pick up the
INCRA JIG Projects
and Techniques, available from
you local INCRA dealer. This
148 page book contains detailed
plans with over 400 illustrations
and photos to build 14 of
Perry McDanielʼs intriguing
original projects.
