Page 2
INCRA
PUSHGUARD
OWNER’S MANUAL
Fig. 2
Attach Deflector Shield
Deflector
Shield
OPERATION
Attach Deflector Shield
Use ONLY the washers, screws, hex nuts and rectangular
nuts supplied with this product during assembly. DO
NOT use substitutes. Add a lock washer followed by a
flat washer to each of the (2) 1/4-20 x 1-1/2” Phillips Pan
Head screws and insert into the holes located on the
top of the Hand Guard, Fig 2. Loosely thread a 1/4-20
rectangular nut onto each of the fasteners. The raised
rim around the hole on the rectangular nuts should
be facing up. Now slide the Deflector Shield between
the rectangular nut and the underside of the recess in
the Hand Guard. Tighten the fasteners to secure the
Deflector Shield.
To Remove the Deflector Shield
The Deflector Shield is designed for use during free-form
edge cuts made using bearing or template guided router
bits. If you are performing more common cuts using a
fence system, the Deflector Shield should be removed.
Just loosen the (2) Phillips Pan Head screws and slide
the Deflector Shield off, Fig 3. Always securely
re-tighten the fasteners before making any
cuts.
Fig. 3
Removing Deflector Shield
Loosen
Phillips
Screws
Slide Deflector Shield Off
Then Re-tighten Fasteners
1/4-20 Rectangular Nut
Common Fence Guided Cuts
For fence guided cuts, the Deflector Shield should be
removed. ALWAYS CONFIRM YOUR SAFE
CUTTING ROUTINES! With the router turned off
and the bit below the table surface, perform a “dry run”
with your workpiece to make sure you are comfortable
with the routine and your safety equipment usage
before making any cuts. Leave space between the fence
and PushGuard to avoid drag and provide clearance for
your cutter guard.
Free-form Cutting with Bearing and Template
Guided Cutters
For this type of cut the addition of the Deflector Shield
provides additional eye protection from chips generated
during the cut. You should still always wear
Safety glasses and again, confirm your safe
cutting routines. Perform a dry run to make
sure that the Deflector Shield safely clears
the cutter.
1/4-20 x 1-1/2”
Phillips Pan Head
1/4” Split Lock
Washer
1/4” Washer
MADE IN THE
USA
Manufactured by:
Taylor Design Group, Inc.
P.O. Box 810262 Dallas, TX 75381
www.incra.com
P: 972-242-9975/F: 972-242-9985
INCRA is a Registered Trademark of Taylor Design Group, Inc.
You can also register your INCRA product
online at www.incra.com
Scan this QR code to register your product online
It’s quick and easy!
ONLINE WARRANTY REGISTRATION
