Incra LS Positioner, Руководство пользователя

Страница: 10 / 16

10 INCRA Woodworking Tools & Precision Rules
Attach the Cap extender
Place a ¼” washer on each of the (2) #10-32
x ½” Phillips pan head screws and insert through
the slotted holes located in the fence cap extender.
Loosely thread a #10-32 hex nut onto each fastener,
then slide the hex nuts into the T-slot located on
the top of each fence cap brace. Position the cap
extender so you can later gain access to the socket
head fasteners on each fence cap brace through
the slotted holes. Pull the cap extender forward
until it firmly contacts the back of each brace and
tighten the (2) Phillips head screws. See Fig. 19 and
Detail 19A.
Attach and Align Fence Cap
Place the 24” long fence cap on top of the cap
extender and attach using the (2) ¼-20 x 5 /
8
” socket
head cap screws with ¼” washers and lock nuts.
Use a straightedge to align the leading edge of the
fence cap with the front face of the Wonder Fence
and tighten the two cap mounting screws, Fig. 20 .
To remove the fence cap and braces, just remove the
two fasteners that secure the braces to the top of the
Pro II or TS Fence and lift the entire unit off, Fig. 21 .
Place the fasteners back into the threaded holes in
the dual pilot rectangular nuts for storage.
2
3
FIg. 19
Attach cap extender
First: Insert
fasteners and
slide #10-32
hex nuts into
T-slot on top
of braces
#10-32 x ½”
Phillips screw with
¼” flat washer
Second: Position cap
extenders to allow future
access to socket head
screws through slotted
hole
Fence cap extender
DETAIL 19A
Third: Slide
cap extender
forward to
contact brace,
then tighten
screws
Brace
FIg. 20
Attach and align fence cap
First: Attach
fence cap to
cap extender
Second:
Use
straight-edge to
align fence cap, then
tighten screws
Fence cap
FIg. 21
To remove fence
cap and braces,
unscrew the
(2) ¼-20 x 5 /
8
”
socket head
screws
SHOP StOP
When used in conjunction with your new Pro II
Fence or Wonder Fence, the INCRA Shop Stop
provides the same precise positioning capabilities
that your LS Positioner offers. The patented
incremental positioning of INCRA’s saw-toothed
racks found on the Shop Stop and your INCRA
fence allow perfectly repeatable stop locations
at any multiple of
1
/
32
” (1mm for metric version.)
The two-piece body can be micro adjusted to any
position between steps and can be configured to
clamp to your fence even when using wooden sub
fences up to ¾” thick. Follow the instructions on
the next page to set up and use the Shop Stop.
Shop Stop
¼-20 x
5
/
8
” socket head screws