Pairing
It-Receive will work with any of the transmitting devices in the
Simply Works range, including: it-Switch, it-Send, it-Send Pro,
it-Roll and it-Stick. In the instructions below these devices are
referred to as “transmitters”.
Before they can communicate with each other they must be
paired by following this procedure:
1. Ensure the it-Receive is connected to your computer.
2. Place the transmitter to be paired close to the it-Receive
(within 1 metre).
3. Press and release the PAIR button on the front of the it-
Receive. The red light next to it will begin flashing.
4. Within 10 seconds press and release the PAIR button on the
transmitter.
5. The light will continue to flash while the devices communicate
with each other.
6. Once the pairing is successful the red PAIR light will stay on
for 5 seconds.
7. If the light continues to flash for 30 seconds and then stops,
repeat the process above. If it still does not pair successfully
then refer to the Troubleshooting section.
Repeat the process above to pair further transmitter devices with
the it-Receive. You can pair up to six transmitter devices, which
will work simultaneously. The pairing information is retained in
the it-Receive’s memory even when your computer is turned
off.
Содержание it-Receive
Страница 1: ...Inclusive Technology www inclusive co uk ...
Страница 7: ...Notes ...