HOW TO INSTALL INCINOLET
1. Remove all packing materials.
2. Set unit on level floor in desired position:
Allow clearance at rear for wiring and vent-line
connection. Allow at least 4” on left side and plenty of
room on the right side to operate foot pedal.
3. Prepare electrical supply within 4 feet of toilet location.
(see instructions below)
4. Install mounting plate to floor (Model WB only - Fig. 3).
5. Connect vent-line.
6. Plug INCINOLET into the proper receptacle on a
20-amp circuit. Dedicated circuit recommended.
Do not install in an explosive atmosphere.
NOTES:
Vinyl floors and some synthetic carpets may discolor.
In such installations, you may want to put a sheet of aluminum
under INCINOLET to dissipate heat. Keep bedding, curtains and
other flammable materials away from contact with the INCINOLET.
Electrical Preparation
This appliance has a 20-amp plug and is meant to fit
only
into a 20-amp
receptacle. (Fig. 4) If the outlet you intend to use for the INCINOLET is
not the proper type, then change the receptacle. You must have a circuit
suitable for 20 amps, headed by a 20-amp circuit breaker. Do not
attempt to defeat this safety feature by modifying the plug in any way.
Power cord is 4 feet long.
Extension cords should not be used with this appliance.
Preparing Vent-Line
Vent pipe can run horizontally or vertically. Venting materials can be placed within a wall and INCINOLET can be
placed close to a wall at the back. Allow 6 to 8 inches on the right side (facing the toilet) to operate the foot pedal.
4” clearance required between sides of toilet and wall. No clearance needed between pipe and wall.
Vertical vent-line should terminate with a rain cap. For horizontal venting use a dryer flap or add a PVC elbow turned
downward to prevent back-drafting.
Models WB and RV are supplied with a mounting plate to secure
the toilet against movement and protect it from vibration.
•
•
4
120 volts
5-20R
125v-20 amps
6-20R
250v-20 amps
240 volts
Fig. 3
Fig. 5
Fig. 4
