29-UC-REN1-NAV
RENAULT ISO Canbus
STEERING CONTROL INTERFACE
WITH NAVIGATION RETENTION
Laguna III 2007>
Clio III 2009>
This interface will automatically turn on the navigation unit when the engine is
running.
You can manually turn on the navigation unit by pressing and holding the mute
button on the steering wheel.
This interface needs to be set up for the make of head unit being fitted.
Use this interface along with a head unit specific patch lead, there is a 4pin black
connector at the end of 3 wires from the UNICAN interface, this is where you will need to
connect the head unit patch lead.
When connected, the CANbus interface will automatically recognise the vehicle. The
green LED on the interface will repeatedly flash once followed by a pause.
You will need to set the interface to the make of head unit you are fitting.
The amount of flashes between pauses corresponds to the make of head unit, see the
table overleaf for the number of flashes and which make it corresponds to.
While the LED is flashing green, press the Vol +/- buttons on the cars steering wheel to
change the amount of flashes between pauses, Vol + will increase the amount of flashes,
Vol– will decrease the amount of flashes.
When you have the correct amount of flashes, press seek+ to confirm and the LED will go
to a solid green light.
Mini ISO
UNICAN PLUS
105.1 mHz
Connect the YELLOW
WHITE wire to the MUTE
input of the aftermarket
radio
NAVIMUSIC
Connect the wire YELLOW
WHITE of navimusic with the
YELLOW WHITE
of the P&P cable
Connect the 29-UC-REN1-NAV to the
vehicle as detailed in the diagram.
