Q U I C K S T A R T G U I D E
SUPPORT
Telephone: 1300 11 4357
Email: [email protected]
DETAIL S
Product Size (W, D, H):
895mm x 500mm x 554—1034mm
Congratulations on your new InAlto
90cm Flat Glass Rangehood!
M O D E L
/
I R G F 9 0 S
W W W . I N A L T O . H O U S E
INSTALL ATION
Please refer to the dimensions of your
rangehood shown in the diagram on the right.
When positioning the rangehood for installation
and use, we advise that the rangehood is mounted
at a height of between 600—800mm above the
cooking surface for safety and performance of
your rangehood.
Gas cooktops must have a minimum of height of
650mm from the burner to the underside of
the rangehood.
Electric cooktops must have a minimum height of
600mm from the cooktop surface to the underside
of the rangehood.
For a complete guide, refer to the user manual
pages 5, 7—8.
6
Controls
Off button
Used for turning off the fan.
Low Speed button
This speed is used for basic ventilation on the kitchen. It is suitable
for simmering and cooking which does not make much steam.
Medium Speed button
This is ideal for standard cooking operation.
High Speed button
When a high density of smoke or steam is produced, use this speed for the
highest effective ventilation.
Light button
Pressing this turns the lighting on or off.
OPERATING YOUR RANGEHOOD
Your
Esatto
Canopy rangehood features push button controls with three speed
levels of extraction.
*
Note: If Low / Medium / High speed buttons are press at the same time,
the unit will only operate at the highest speed.
THE CONTROL S
Your Flat Glass Rangehood Controls
1
Stop
2
Low Fan Speed
3
Medium Fan Speed
4
High Fan Speed
5
Light
For a complete guide on operating your
rangehood refer to user manual on page 6.
1
2
3
4
5
5
Specifications
Model
Product dimensions (W,D,H mm)
ERGF90S
895mm × 500mm × 554–1034mm
Model
Extraction
Other features:
ERGF90S
750m3/hr extraction
– 3 speed push button control
– 2 ×
2
W LED lights
–
2
×
Aluminium filters
YOUR RANGEHOODS
Rangehood components
Your
Esatto
Canopy Rangehood is supplied with:
– 1 × Rangehood
– 1 × Expandable 150mm ducting adapter
– 1 × Packet of fasteners and wall plugs
– 2 × Stainless Steel flue pieces (upper and lower)
– 1 × Wall Bracket (“hook”) for the rangehood
– 1 × Wall Bracket for the inside of the chimney pieces
– 1 × “Outside Chimney” bracket
Typical installation tools required
You’ll most likely require the following tools/equipment
(not supplied) for the installation of your rangehood.
– Electrical drill
– Tape Measure
– Screw-driver
– Spirit Level
If ducting your rangehood, you’ll also most likely require:
– Jig saw
– Ladder
– Duct-tape
– Ducting
