SmartNode Installation
57
Figure 10-10: SmartNode 2000 Series Rack Mounting Bracket Location Holes
10.19 Wall-Mounting for SmartNode 1000 Series
As shown in Figure 10-11 a SmartNode 1000 Series may also be wall-mounted by suspending it from
the two recesses on the underside that are situated nearest to the LED side of the SmartNode.
Figure 10-11: SmartNode 1000 Series Wall Hanging Points
10.20 Connecting Cables
Warning:
Do not work on the SmartNode, or connect or disconnect cables during periods of
lightning activity. Refer to the safety advice section in this document for more information.
10.20.1 Cables and Connections for SmartNodes
Cabling information and pin-out data are provided in Appendix A to this document.
10.21 Perform Initial Configuration
A summary of the procedures for the initial software installation of a SmartNode is provided in the
Quick Start Guide that is provided with each type of SmartNode. These procedures are described in
more detail in the SmartWare Software Configuration Guide.
The procedures for configuring the voice and data features are described in the companion
document SmartWare Software Configuration Guide. Check that the document version is the one
that matches your Software release and build number.
10.22 Where to Go Next
Additional documentation is available on the documentation CD-ROM or you can access the most
current Inalp documentation on the World Wide Web at:
Hardware Installation Guide, Revision 3.11
