18
SmartNode SN1400 Hardware Description
2 SMARTNODE
SN1400
HARDWARE
DESCRIPTION
The SN1400 is a compact voice-data access device, which supports four voice channels. The
interfaces consist of two ISDN BRI and two Ethernet 10BaseT. It is suitable for enterprise networking
and small office environments. The ventilated metal case can be wall-mounted or placed on a
desktop. The SN1400 complies with all relevant EU directives.
2.1 Physical
Description
•
Chassis W / H / D: 220 / 40 / 160 mm
•
Weight: 600g
•
CPU Motorola MPC850 @ 50MHz
•
Memory 16MB SDRAM
•
Flash 4MB
•
4 channel DSP
•
Power dissipation 4W
•
Power supply AC 100 - 240 V, 50/60 Hz, 70 mA
2.2 Front
Panel
The front view of the SmartNode 1400 is depicted in Figure 2-1 below.
Figure 2-1: SmartNode SN1400 Front View
•
Two LEDs (’POWER’, ’RUN’) indicate the device status.
•
Four LEDs (‘BRI0’, ’BRI1’, ’ETH0’, ’ETH1’) indicate the status of the interfaces.
See Chapter 11, “Led Indications”, for detailed information on LED states.
2.3 Rear
Panel
The rear view of the SmartNode 1400 is depicted in Figure 2-2. Two ’LINK’ LEDs show the Ethernet
status and two ’ L2’ LEDs show the BRI status. See Chapter 11, “Led Indications”, for detailed
information on LED states. See Appendix A for connection cables and pin out data.
Figure 2-2: SmartNode SN1400 Rear View
The available ports are tabulated in Table 2-1 below. The ports are labeled with the interface type
above each socket, as shown in the Port column of the table.
Hardware Installation Guide, Revision 3.11
