5
Mounting your speakers on a wall
NOTICE:
Do not mount the speaker on surfaces that are not sturdy enough,
or have hazards, such as electrical wire or plumbing, concealed behind them.
If you are unsure about installing the speaker, contact a qualified
professional. The brackets were specifically designed to support the weight
of ‘Collage’ only.
1.
Place the wall-mounting bracket of the Collage speaker in the desired
location against the wall and mark the screw locations (x2) with a pencil,
using the bracket as a template. Use a tape measure to measure the
height from the floor to the marked holes and make sure they are level
and equidistant. If you plan to feed wires through the wall, mark the
pilot hole position first.
2.
Choose the screws to fit the hole of the wall-mounting bracket, however
if your wall surface is hard, like concrete, drill pilot holes to insert
anchor plugs for the screws to engage with. Remember always
measure twice
3.
Secure the screws (x2) on the wall.
4.
Mounting operation is simple (see the picture inset), just hanging the
wall-mounting bracket of the Collage speaker on the screws. The
speaker now is ready to use.
NOTICE:
The
ELECTROSTATZ
™ tweeter panels, LHS & RHS, are dipole
i.e. sound waves travel in both directions. To maintain the highest quality
acoustic performance, never block the rear sound output area and always
maintain at least a 3cm distance between the tweeter panels and the wall.
The mounting bracket will automatically provided the clearance required
