in-lite HYVE 22, Руководство пользователя

Страница: 4 / 8

EN
Contents
1x HYVE 22 12 V / 0.25 W
Dimension Ø 22 mm / 0.9 inches
Recess height 50 mm / 1.96 inches
1x Easy-Lock
Material
Impact-resistant polycarbonate, filled with a 2-component resin
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Use
Integrated lighting suitable for highlighting paths, drives, patios, pond
edges etc.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life and a high light output and their power consumption
and the heat produced are extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.
EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
This fixture can be built into various sorts of decorative paving, such
as concrete or natural stone, or wooden constructions such as deck-
ing, walls, fences, pond edges etc.
General Installation Guideline
During installation, make sure that all components are easily acces-
sible for replacement.
Step 1
For installation in wood use a suitable saw/drill to saw/drill holes with
a diameter of 22 mm / 0.87 inches. If working with stone or similar ma-
terials, use a diamond drill bit (Ø 22,4 mm / 0.88 inches), available from
your dealer. Drill holes where appropriate before beginning to fit the
fixture. (Fig. 1)
Step 2
Feed the connector for the fixture through the hole and then carefully
insert the fixture into the recess. Use a clean synthetic hammer to do
this. (Fig. 2)
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 3)
a. There are two cable grips. The grip with the wider recess fits the
10/2 main cable, the grip with the narrower recess fits the 14/2
main cable. Clamp the correct cable grip over the main cable.
b. Put the cable grip (with the cable underneath) in the Easy-Lock
connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 4
Connect the power cable to the fixture by connecting the mini-
connector. (Fig. 4)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 3, 4 and 5. When the fixture is connected to
the main cable also check that the contacts of the Easy-Lock connec-
tor are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.