IMT VSTx, Руководство пользователя

Страница: 32 / 50

VST
X
User Manual
Revision 2. 3 32
4.3 Physical Installation
Note: The VST
X
is configured via the programmable serial interface. Should you desire to program the
unit while in your application, then you r application design must provide a means to connect to the
serial interface. If your application cannot support a means to connect to the serial interface, then you
must pre-configure the unit prior to installation. Refer to Section 5.
The VST
X
can be mounted using the four screw holes located on the corners of the housing, using four
#2-56 screws. Tighten the four screws gradually in rotation, without applying excess force on one
before starting the others.
The STx requires installation using proper thermal dissipation methods. During operation, energy is
dissipated to the outside environment, especially on the lower surface of the unit.
The bottom surface of the VSTx must be kept at a temperature within the operating temperature range
specified in Chapter 3.
The unit has an internal fan and the fan openings must not be blocked.
The unit should not be operated inside another enclosure unless sufficient cooling is provided that the
case temperature is within the range specified in Chapter 3.
Figure 4-6: VST
X
Outline Drawing, Connector Housing (Dimensions in Inches)