INSTRUCTIONS OF USE
The product is delivered with a single phase 220V / 50 Hz plug. In order to ensure an optimum use, the product
should be connected to an electrical installation with minimum protection 25A (ideally 32A), and protected
according to applicable standards. See the instructions for electrical connections on page 20.
Turn the ON/OFF switch to the ON position. Press the induction heating activation button (4) described on page
5. The light on button 6 blinks indicating that the product is ready to heat. Position the inductor (8) flat on the
part or the area to heat up, placing the open part of the ferrite against the part. Press the red button (7) on the
handle of the inductor to start heating; if necessary move the inductor in order to heat up a larger surface on
the part. After stopping the heating, decrease the heating power level on the control panel, and secondly only
switch off the product; this way the cooling circuit will reduce the temperature of the inductor before switching
off completely the product.
RESIDUAL RISKS
WARNING!
The machine has been designed to ensure maximum safety. The possibility exists that the operator may get
burnt if he touches hot parts.
WARNING!
The machine must not be used near sensitive materials or dangerous explosives, compressed gases, flammable
liquids, electrical equipment.
Metal objects may not be worn in the vicinity of the inductor, as they will become hot (rings on finger for
example).
It is forbidden for people wearing pace-makers or any other biomedical equipment to use this product.
Noise and vibrations
The machine produces a sound pressure level for continuous use of less than 60dB (A).
The machine does not generate significant vibrations that may cause danger.
Demolition and disposal
Some materials, with which the machine is built, can be recycled, therefore the recycling of the product should
be performed in accordance with relevant local regulations.
Unpacking and installation
The machine is supplied ready for use. Before operating, you must remove all packing material and place the
product carefully in a suitable place (ground even, dry and ventilated place).
WARNING!
The installation must be designed to allow easy access to all its parts. A minimum space around the product
must be guaranteed for good operation and maintenance, without problems and risks for the operator.
Replacing the inductor
WARNING!
The replacement of the inductor should be performed only by authorized staff and only after removing power to
the machine.
WARNING!
During maintenance and / or repair, wear protective gloves. Electrically isolate the machine by disconnecting it
from the mains.
WARNING!
It is forbidden to start using the machine if all the metallic covers have not been screwed back on the product
and if all the safety devices are not operational.
053410_01 01 2015_V1.1
- 7 -
