For contact information, visit www.improvedracing.com
5
9. Place all four of the new M4 screws to their respectable holes in the top
half of the thermostat.
9
10. Hand-start each screw, followed by fully hand-tightening the screws with
a 3 mm tool.
11. Use a 3 mm driver and torque wrench to torque the screws in a crisscross-
ing pattern to 25 lb-in. DO NOT EXCEED THIS TORQUE.
11
12. Perform a second pass in the same pattern to validate the torque value
on the fasteners.
13. Release the clamp.
The rebuild has been completed!
2
4
5
6
7
8
11
6
5
4
3
2
1
3
9
Figure 2 - FSM-XXX-RKIT Disassembly & Reassembly Steps