1
Determine where the Aqua-grade linear will be installed.
(if the product is being installed into an existing floor the
screed will need to be excavated first.)
2
Measure out and mark the position of the waste pipe
and gully.
3
Using appropriate tools, excavate enough concrete
to allow the waste to be fitted.
5
Take the yellow starter section and screw in the
levelling feet. Then clip the feet mounting plates onto
levelling feet.
4
Install the gully and waste pipe in an approved manner.
6
Position the starter section correctly and mark the
position of the mounting plates. Temporarily place the
drain channel into the starter section and connect the
waste to ensure correct positioning.
Section 4: General Installation guidance
for all configuration types
This section covers parts of the installation that are are common to all configuration types.
Please see section 5 and follow the relevant stages that are applicable to the type you are installing.
Page 5
