Impex MARCY PLATINUM MP-3500, Руководство пользователя, Страница: 8 / 31

ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended this machine be assembled by two or more people
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Place a Weight Stack Cover Base (#68) onto the Rear Stabilizer (#16). Secure it to the
Rear Stabilizer with two M8 x 5/8” Allen Bolts (#104) and Ø 5/8” Washers (#112). Insert
two Guide Rods (#17) through the holes on the Weight Stack Cover Base into the Rear
Stabilizer. Secure each Guide Rod with one M10 x ¾” Allen Bolt (#103) and Ø ¾”
Washer (#111) from the bottom. Slide two Ø 2 3/8” x 1” Rubber Bumpers (#52) onto the
two Guide Rods.
B.) Do not tighten the Nuts and Bolts in the following procedures until instructed to do so.
C.) Attach the Vertical Frame (#4) onto the Rear Base Frame (#15). Secure it with two M10
x 2 5/8” Carriage Bolts (#106), one 4 ¾” x 2 ¾” Bracket (#25), two
∅
¾” Washers
(#111), and two M10 Aircraft Nuts (#109).
D.) Attach the Butterfly Base (#13) to the Rear Base Frame (#15). Attach the Front Base
Frame (#12) to the Butterfly Base (#13). Make sure the L shaped bracket welded on the
Butterfly Base (#13) face towards the front of the machine (see small diagram in the
square insert in Diagram 1). Align the holes and secure them together with two M10 x 2
5/8” Carriage Bolts (#106) from the bottom, two M10 x 3 5/8” Carriage Bolts (#105) from
the side of Butterfly Base, four Ø ¾” Washers (#111), and four M10 Aircraft Nuts (#109).
E.) Connect the Rear Base Frame (#15) to the Rear Stabilizer (#16). Secure them together
with two M10 x 3 5/8” Allen Bolts (#96), two Ø ¾” Washers (#111), and one 2 ¾” x 1 ½”
Bracket (#36).
F.) Attach the Foot Plate (#14) to the Front Base Frame (#12). Align the holes and insert the
Foot Plate Axle (#37) through the holes.
G.) Slide 14 Weight Plates (#80) onto the Guide Rods. Make sure the deep groves on all
Plates face down and toward the back. Insert the Selector Rod (#17) through the center
hole on the Weight Plates. Slide the Weight Selector Stem (#81) onto the Guide Rods.
H.) Use the Weight Plate Selector Pin (#74) to select desired number of Weight Plates to
exercise. NOTE: Each Plate weights approximately 10 lbs. Please refer to the Weight
Resistance Chart on page 28.
7