Impax IM180-6L, Руководство по эксплуатации, Страница: 9 / 16

9
Preparing For Use
Before connecting your compressor to the
mains supply, check the following:-
• The mains voltage is 230V.
• The ON/OFF switch is in the OFF (non-
depressed) position.
• The pressure regulator should be set at its
lowest setting, i.e. turned fully anticlockwise.
• If the machine has not been used for 24
hours or so, open the drain valve tap to drain
any condensate which may have
accumulated.
When clear, close the valve.
Important: If the receiver is under pressure,
keep your hands well away from the air being
expelled.... remember, compressed air is
dangerous!
Warning! Before connecting any air tool, make
sure you have read and fully understood the
manufacturers instruction booklet for the tool
being used.
Also ensure that the tool is compatible with the
compressor and hose specifications.
If the pressure rating of the tool is less than 8
bar, the pressure regulator must be used to
adjust the output pressure.
Switching On and Off
Warning!
Switching On & Off must be done
using the On/Off switch mounted on the
compressor. Switching the compressor Off at
the mains supply can damage the motor and
will invalidate the guarantee.
Before switching on the power supply to the
compressor check that the On/Off switch is in
the Off position (non-depressed) (Fig.1).
Check that the pressure regulator is closed
(turned fully anti-clockwise) (Fig.2).
Check that the drain valve tap is closed (Fig.3).
Connect the compressor to a suitable 13A
mains supply. Switch on the compressor by
pressing the On/Off switch to the ON
(depressed) position (Fig.4). The compressor will
now start.
OPERATING INSTRUCTIONS
Fig 1
Fig 2
Fig 3
Fig 4