Impax IM-MMA130-IWK, Руководство пользователя, Страница: 14 / 36

13
SAFETY INFORMATION
4. ALWAYS use the correct regulator. Each
regulator is designed to be used with a
specific gas.
5. ALWAYS inspect the hose before use to
ensure it is in good condition.
6. ALWAYS keep the free length of gas hose
outside the work area.
7. ALWAYS remove all flammable materials
from the welding area.
8. NEVER remove any of the panels unless the
machine is disconnected from the supply,
AND never use the machine with any of the
panels removed.
9. NEVER attempt any electrical or mechanical
repair unless your are a qualified technician.
If you have a problem with the machine
contact your local IMPAX dealer.
10. NEVER use or store in a wet/damp
environment. DO NOT EXPOSE TO RAIN.
11. NEVER use gas from a cylinder, the content
of which is unknown. It is important to
ensure the appropriate gas is being used.
12. NEVER use a damaged cylinder.
13. NEVER lift the cylinder by the valve.
14. NEVER expose the cylinder to a heat source
or sparks.
15. NEVER continue to weld, if, at any time, you
feel even the smallest electric shock. Stop
welding IMMEDIATELY, and DO NOT
attempt to use the machine until the fault is
diagnosed and corrected.
16. NEVER use the welder with input
connections greater than 10M in length.
17. NEVER point the torch at any person or
animal.
18. NEVER touch the torch nozzle until the
welder is switched OFF and the nozzle has
been allowed to cool off.
19. NEVER connect, disconnect, or attempt to
service the torch, until the machine is
switched OFF and disconnected from the
mains supply.
20. NEVER allow the cables to become
wrapped around the operator or any person
in the vicinity.
21. Safety devices such as interlocks and circuit
breakers should not be disconnected or
shunted out.
22. Before installation, inspection, or service of
equipment, shut OFF all power and remove
line fuses to prevent accidental turning ON
of power.
23. Do not open power circuit or change
polarity while welding.
24. If, in an emergency, it must be
disconnected, guard against shock burns, or
flash from switch arcing. Always shut OFF
and disconnect all power to equipment.
Power disconnect switch must be available
near the welding power source.
25. Fully insulated electrode holders should be
used. Do NOT use holders with protruding
screws or with any form of damage.
26. Fully insulated lock-type connectors should
be used to join welding cable.
27. Frequently inspect cables for wear, cracks
and damage. IMMEDIATELY REPLACE
those with excessively worn or damaged
insulation to avoid possibly lethal shock
from bared cable. Cables with damaged
areas may be taped to give resistance
equivalent to original cable. Keep cable dry,
free of oil and grease, and protected from
hot metal and sparks.