Flash & Modeling Lamp Settings
(continued)
Page 8
Page 9
To Set the Modeling Light Output Only
Press the MODE button twice. The display
will read “M/Lamp Adjust” and a numerical
value. Press the up/down arrow buttons to
adjust the modeling light output. When
done, press the ENTER button. The new
output value will show in the display.
To Set the Flash and
Modeling Light Output Together
Press the MODE button three times. The
display will read “M/Lamp and Flash
Output.” Press the up/down arrow buttons
to adjust the modeling light and flash output.
When done, press the ENTER button. The
new output value will show in the display.
Notes:
1
After pressing the MODE button the display will return to the main window
if no entry is made within 7 seconds.
2
The modeling light will turn off when the flash is triggered.
3
Your settings are retained even when the flash unit is turned off.
Audible Beep Settings
A beep will sound once when the flash is
recycled and ready to flash. You can turn
this audible beeper off.
To Set the Audible Beeper Tone
Press the MODE button four times. The
display will read “BEEP” and the current
setting. Press the up/down arrow
buttons to adjust the setting to ON or
OFF. When done, press the ENTER
button. The musical note will display if
the beeper is on, and will not display if
the beeper is off.
Audible Beep is ON.
Audible Beep is OFF.
M/Lamp Adjust:
BEEP: ON
BEEP:
OFF
M/Lamp and Flash
output:
Flash:
Voltage:
AC V
F / Times:
Times
Flash:
Voltage:
AC V
F / Times:
Times
10M
25M
50M
75M
100M
10Y
25M
50M
75M
100M
