Measurement of Concentration:
You can determine the dispensed water-to-product ratio for any metering tip size and viscosity. All that is
required is to operate the primed dispenser for a minute or so and not two things: the amount to dispensed
water/product mixture, and the amount of concentrate used in preparation of the solution dispensed. The water-
to-product ratio is then calculated as follows:
Dilution (X) = Amount of Mixed Solution --- Amount of Concentrate Drawn
Amount of Concentrate Drawn
Dilution ratio, then, equals X parts water to one part concentrate (X:1). If the test does not yield the desired
ratio, choose a different tip and repeat the test. Alternative methods to this test are 1) pH (using litmus paper),
and 2) titration. Contact your concentrate supplier for further information on these alternative methods and the
materials required to perform them.
Problem
Cause
Remedy
1. Unit does
not draw
concentrate
a. Clogged suction tube strainer
a. Clogged suction tube strainer
b. Metering tip orifice obstructed
b. Metering tip orifice obstructed
c. Water pressure too low
c. Water pressure too low
d. Mineral deposits in barrel of
d. Mineral deposits in barrel of
foamer
foamer
e. Clogged water inlet strainer
e. Clogged water inlet strainer
(low water flow)
(low water flow)
a. Clean or replace
b. Rinse tip or replace: Do not attempt to clean: may alter size of orifice
c. Minimum 25 PSI required
d. Back flush unit. Remove container, suction tube and metering tip. Put finger
over barrel opening. Apply minimal water pressure through garden hose
nozzle of barrel to be flushed.
e. Descale foamer by soaking in weak descaling solution
f. Clean or replace strainer.
2. Weak
foaming
action
a. Clogged water inlet strainer
b. Water pressure too low
c. Water temperature too high
a. Clean or replace
b. Minimum 25 PSI required
c. Use lower temp water source. (Concentrate flow decreases above 140˚F
water)
If above steps fail to produce good concentrate draw and/or foaming action, replace lid assembly. See component chart below.
KEY
PART NO.
DESCRIPTION
1
10083713
10083713
Spray gun and quick disconnect
2
10061501
Foamer lid assembly
3
688201
688202
Concentrate container - 96 oz.
Concentrate container - 48 oz.
4
690014
Metering tip kit
5
500808
Suction tube, 8”
6
609600
Foot Strainer
Troubleshooting:
Parts List:
#7504 FOAM GUN INSTRUCTIONS
impact-products.com
419.841.2891
800.833.1541
Impact Products LLC.
2840 Centennial Road
Toledo, OH 43617
7504 Instructions (REV 01/21)
