Installation procedure (Example using option card OPC-DIO)
Press the indented locations (indicated
with
à
) to release the lock, allowing the
cover to be opened.
Step (2) details
(1)
Remove the bottom cover
(2)
Open the top cover
(3)
Remove the touch panel
(5)
Pass the harness
through to the inside
of the attachment
(4)
Connect the harness to the
inverter connector
(larger side of the connector)
(6)
Attach the
attachment to
the inverter
(6)
(6)
(6)
(7)
Connect the connector on the
opposite end of the harness to
the attachment connector
Note
Ensure that all connectors have been inserted fully and are locked.
Thank you for purchasing the option attachment “OPC-E2-ADP1”
The use of this option attachment allows the Jaguar VXT series to be equipped with option cards (sold seperately).
1.Product Check
Please check the following before using the product
(4) Check the model on the nameplate and ensure that
the product is the same as ordered.
(5) Ensure that the package contains both the attachment
and accessories.
(6) Ensure that neither the attachment nor the
accessories have suffered damage such as breakage
or denting during transport.
(7)
Refer to the “1.1 Product Configuration” diagram on
the right for details of the nameplate attachment
location and accessories.
Attachment
Nameplate
Harness
Tapping screw
(M3 x 14)
2
Screw
(M3 x 6)
1
1.1 Product Configuration
If anything is out of place, or the product appears to be
defective, contact IMO.
2.Specifications
The applicable scope for this product is as follows:-
(1) Applicable models
(2) No. of installable option cards: 1
Series Name
Inverter Capacity
Jaguar VXT
VXT-4A-2 / 2E ~ VXT-20A-2 / 2E
VXT-2A-4 / 4E ~ VXT-44A-4 / 4E
VXT-3A-1 / 1E ~ VXT-11A-1 / 1E
3.Installation Method
WARNING
Please wait at least 5 minutes after inverter power has been turned OFF before attempting installation and wiring.
Also, ensure that the touch panel LEDs are OFF, and use a tester to confirm that the DC intermediate circuit voltage across main
circuit terminals P(+) and N(-) has dropped to a stable value (+25 VDC or lower).
Risk of electric shock
Note
Wire the inverter main circuit terminals and control circuit terminals before installing this attachment.
STEP 1
First, wire the inverter main circuit terminals and control circuit terminals
STEP 2
Follow the installation procedure on the next page to install the attachment
STEP 3
Install the option card
STEP 4
Wire the option card to the attachment ground wire and option card terminals
Note
Secure the wiring near the inverter to prevent the weight of the wiring being applied to the option card.
