Fig
. 4 dismounting
When you want to use the wheelchair
without the or you want to fold
it, it is easy to take off the power pack.
Turn off the power and disconnect the
speed control unit. To do so, you need to
press in the catch on the socket and at the
same time pull the plug.
If you choose to let the speed control unit
stay on the handle, please make sure the
cable is not tangled with the rear wheels.
If the chair is to be folded and packed into
the boot of a car, you should take off the
speed controller and keep it in a safe place.
Lift up the pedal and lower the
onto the ground.
Lift the two pawls out of their sockets on
the pedal arm and let the straps hang down
beside the power pack.
Go to the front of the chair, release the
finger screw on the traction bar and slide
the pin into the tube. Then pull the traction
bar out of the bracket on the opposite side
and lower the front end of the .
Now you can push the chair forwards and
leave the power pack on the ground.
REMEMBER to tighten the finger screw to
avoid the pin to get lost.
Fig. 5 disassembling and handling
If you need to lift and handle the ,
please note the weight:
32 kg.
Therefore, never attempt to lift the power
pack without taking it apart!
Pull out the red plug in front of the battery
and release the finger screw. Then lift off
the battery by the handle/strap and you can
now lift the motor unit grasping the pedal
arm and the traction bar.
fig. 4
1
3
2
fig. 5
