ImmersionRC XuGong, Руководство по сборке

Страница: 2 / 33

Important Note:
This build log is currently a work in progress that can really benefit from input from anyone
using it. Please send any suggestions/updates to
info@immersionrc.com and we will be
delighted to incorporate them in the manual.
A video build log is in progress and will be released shortly.
Pre-requisites, General
● 2mm Hex driver, for installation of the motor mounting screws, and T­Nut screws
● Small Phillips screwdriver (watchmaker’s size, for Hitec self­tapping servo screws)
● Battery, HobbyKing Zippy Compact 4s4000 recommended for most builds. See the
section ‘Battery Choices’ for more details.
● 3M VHB (or similar) double­sided tape for ESC mounting
● M3 x 8mm screws for motor mounting (low profile head, 2mm or less)
● Flight Controller, OpenPilot, or DJI Naza recommended (see below for a DJI­specific
build)
● Two lengths of ~AWG14 wire, red and black, approx. 10cm long (Battery hookup)
● Two lengths of ~AWG20 wire, red and black, approx. 20cm long (Naza hookup)
● Extender cables to connect the motors to the ESCs, length depends upon motors and
ESCs used.
● XT60, or Deans connector according to the battery used
● 4mm single­sided self­adhesive foam for camera mounting
● Tilt servo, HS­65MG highly recommended
● FPV Camera, FatShark CMOS highly recommended
Pre-requisites, Build using DJI Components
● DJI Naza­Lite, or Naza­M V2 (smaller BEC from the Lite is preferred for most builds)
● 4 x DJI 2212/920kV motors, or similar
● 8” DJI Phantom props (small arm version), or DJI 1038 props (new style) for the long arm
version