Immergas RAPAX 300 ERP, Предупреждения и инструкция

Страница: 52 / 56

52
Water heating energy efficiency of the water heater
Water heating energy efficiency of the set in
average climate conditions
Water heating energy efficiency class of the set in average climate conditions
Water heating energy efficiency class in colder and hotter climate conditions
Colder: - 0,2 x =
Hotter: + 0,4 x =
Stated load profile:
Solar contribution
From the board of the solar device
1
%
‘I’
2
%
+
( 1,1 x ‘I’ - 10 % ) x ‘II’ - ‘III’ - ‘I’ =
Auxiliary electricity
3
%
G F E D C B A A
+++
A
++
A
+
< 27 %
< 27 %
< 27 %
< 28 %
≥ 27 %
≥ 27 %
≥ 27 %
≥ 28 %
≥ 30 %
≥ 30 %
≥ 30 %
≥ 32 %
≥ 33 %
≥ 34 %
≥ 35 %
≥ 36 %
≥ 36 %
≥ 37 %
≥ 38 %
≥ 40 %
≥ 39 %
≥ 50 %
≥ 55 %
≥ 60 %
≥ 65 %
≥ 75 %
≥ 80 %
≥ 85 %
≥ 100 %
≥ 115 %
≥ 123 %
≥ 131 %
≥ 130 %
≥ 150 %
≥ 160 %
≥ 170 %
≥ 163 %
≥ 188 %
≥ 200 %
≥ 213 %
M
L
XL
XXL
3 2
3 2
%
%
The energy efficiency of the set of products indicated in this sheet may not reflect the actual
energy efficiency after installation since such efficiency is affected by additional factors, such as
the heat loss in the distribution system and the size of the products compared to the size and
features of the building.
Facsimile for filling in domestic hot water production system package fiche.
Fig. 7-1
7 PARAMETERS FOR FIL-
LING IN THE PACKAGE
FICHE.
Should you wish to install an assembly, starting
from the Rapax 300 ErP or Rapax 300 Sol ErP
water heater, use the package fiche in Fig. 7-3.
To fill it in correctly, enter the figures shown
in table Fig. 7-2 (as shown in the package fiche
facsimile Fig. 7-1) .
The remaining values must be obtained from
the technical data sheets of the products used
to make up the assembly (e.g. solar devices,
integration heat pumps, temperature controllers).
Use sheet fig. 7-3 for “assemblies” related to the
domestic hot water function (e.g.: water
solar thermal system).