ASSEMBLING THE SOFT PART ON TO SOHO BASE
STEP 1
Start by attaching the Gas Lift (IV)
to the center of the base (III).
STEP 2
Place the Plastic Bellow (V) around
the Gas Lift (IV)
STEP 3
Attach body (I) to the base by
sliding it on to the gas lift.
STEP 4
Take pin (VII) out by first sliding out
clip spring. Take the seat off and
place it on the floor.
1
2
STEP 5
Turn backrest back to the floor.
STEP 6
Attach armrest(II) by first entering
one M6 screw (VIII) by a couple of
turns only into top hole and sliding
the arm into the slot on the frame.
Screw in and tighten the next two
M6 (VIII) screws before tightening
the top screw again with hex key
(IX).
I
Body x 1
BODY PART
II
Armrest x 1
III
Base x 1
IV
Gas Lift x 1
V
Plastic Bellow x 1
VI
Clip spring x 2
VII
Screw M8x50 x 1
VIII
Screw M6 x 6
IX
Hex key x 1
or
STEP 7
Go behind the chair and hold the seat as shown in the drawings.
Connect seat and back by either standing straight behind or on
the side of the chair back.
VI x 1 pc.
click
STEP 8
Connect seat to backrest by sliding holes on seat onto pegs on backrest.
Note: one peg is longer to make lining up holes easier. Fasten clip spring
(VI) into slot on the short peg.
STEP 9
Fold seat/backrest assembled to upright position.