21
EN
SPACER COMB ASSEMBLY (8)
The spacer comb is useful for adjusting the length of the cut.
If the hairs to shave are long (from 10 mm), it is recommended to
trim them with the spacer comb before shaving.
•
Insert the spacer comb (8) onto the blade locking device [Fig.C1].
•
Make sure that the comb teeth are set up on the blade teeth.
SHAVING INSTRUCTIONS:
The shaver can be used on dry or wet skin, and can also be used
under the shower or in the bath.
Do not apply cream, soap or foam on the skin when shaving.
•
Turn the appliance on by pushing the on/off (4) switch upwards.
•
Place the blade locking device (1) on the area where you wish
to remove hair, touching the skin [Fig.E].
•
Pulling your skin tight, carefully slide the blade along your skin,
against the direction of hair growth, without pressing too hard.
TO ADJUST THE LENGTH OF THE CUT
•
Insert the spacer comb (8) onto the blade locking device (1).
•
Turn the appliance on by pushing the on/off (4) switch upwards.
•
Place the spacer comb perpendicular to the area where you
wish to remove the hair and gently slide the appliance against
the direction of hair growth [Fig. F].
