Imetec F2115, Инструкция по эксплуатации

Страница: 10 / 68

IT
8
pREpaRaTIon
placInG ThE ElEcTRIc BlankET FIG. (a-B)
IMpoRTanT!
The electric blanket must only be placed between the mattress and the flat sheet and not on top of persons in bed.
• Lay the electric blanket directly on the mattress with the side on which there is the plug (1) facing the mattress.
• Lay the mattress cover making sure to secure it to the mattress using the elasticated corners.
• Make sure the electric blanket is always laid out properly.
• Lay the flat sheet on the electric blanket and then finish laying the bed as usual with a sheet and bed cover.
USE
connEcTInG and REMoVInG ThE TEMpERaTURE adJUsTMEnT conTRol FIG. (B)
IMpoRTanT!
The electric blanket must only be used with the control unit supplied. The relative model is specified on the label
sewn on the panel.
• Insert the plug (2) in the socket (1) to connect the temperature control unit to the electric blanket.
• The same must be done with the second plug in the double bed model.
• Disconnect the plug (2) from the electric blanket by pressing the pushbuttons at the sides of the plug (1).
sWITchInG ThE ElEcTRIc BlankET on and sElEcTInG ThE coRREcT TEMpERaTURE FIG. (c)
IMpoRTanT!
do noT place the control unit under the pillow or under the sheets when in use.
• Switch the electric blanket on from the back of the control unit by setting the switch to ON (I) (8) (Figure [C]).
• QUICK PRE-HEAT - the INTELLISENSE technology automatically sets the temperature to the quick heating setting 6. Do NOT use the 6
QUICK PRE-HEATING temperature when you are in bed.
• Activate the quick pre-heat function when the electric blanket is in stand-by by pressing the temperature button (6) until number 6 on the
temperature display (3) (Figura [C]) lights up red.
• When using the appliance at night or continuously, select the temperature (1 to 5) by pressing the temperature button (6) (figure [C]) until the
desired temperature lights up on the temperature display (3) in orange.
MEMORY FUNCTION
After being used for a few minutes, the electric blanket will memorise the last temperature selected.
aUToMaTIc sWITch-oFF FUncTIon
The electric blanket is provided with an automatic switch-off system. The timer can be set from 1 to 9 hours.
• TIMER – press the timer selector (5) (Figure [D]) until 1 or 9 hours light up green (4).
• AUTOMATIC SWITCH-OFF - once the set time elapses, the electric blanket will switch-off automatically and the stand-by display (7)
(Figure [C]) lights up blue.
DISCONNECTION
• Select the switch-off function on the back of the control unit (8) (Figure [C]) and disconnect the plug from the socket.
CLEANING AND MAINTENANCE
The electric blanket can be washed. Check the washing symbols on the label of the electric blanket to wash it correctly.
Wash at 40°C
Tumble dry at a temperature that is less
than 40°C
Do not bleach Do not iron
Do not dry-clean
wASHING INSTRUCTIONS
• Disconnect the wire from the temperature control unit before washing as shown in fig. (B).
• It is important to measure the electric blanket before washing it in order to verify that the dimensions are approximately the same while drying.
EN
MI000051_multi.indd 8 29/05/12 16.55