2950SCHEDESS_2950SCHEDAES (E101110X_ENG)
20/10/2009
3
Not correct board installation;
Missing
of
a
ordinary
and
programmed maintenance;
Missing or not respect of the
instruction written in the manual;
Tension or supply defects;
Not authorized modification to the
machine.
Use of the machine by not
authorized people;
5. PROGRAM
Put the new board inside its room after
that the behind connectors was taken off.
Connect the new connectors in the
previous position, keypad and display
included.
The board can be supplied also “on the
table” using a 220V~ (phase/neutral) and
supplying the two poles connector called
JP12. Obviously, connect in the same
position the keypad and the display.
Supply the board and press the keys “+”
and “-“ at the same time.
“PASSWORD” should be displayed. If
different messages should be displayed,
then check if the key flat is correctly
connected.
Press “ENTER” and digit the password
“777” to enter in the user menu where,
using the keys “+” and “-“ it is possible to
enter in the following parameters:
LINGUA / LANGUAGE
PROGRAMMI/PROGRAMS
INFORMAZIONI/INFORMATION
PASSWORD
6. LANGUAGE CHANGE
The available languages are:
- ITALIANO / ITALIAN
- HRVATSKI / CROATO
- FRANCAIS / FRENCH
- ENGLISH
- NORSK / NORWEGIAN
- PORTOGUES / PORTUGUESE
- ESPANOL / SPANISH
- DEUTSCH / GERMAN
To change the languange, display the
right one and press “ENTER”.
To exit the menu press “STOP” until the
display
shows “SELECT PROGRAM” (in
the chosen language)
7. PROGRAM MODIFICATION
The programs can be modified or new
program can be created.
The maximum number of programs kept
in memory are 10.
Press the password “777” to enter in the
second level menu “PROGRAMS”, the
following parameter can be visualized
and modified:
- NAME
- CYCLE LENGTH
- ROTATION TIME
- REVERSING PAUSE
- CYCLE TEMPERATURE
- COOLING LENGTH
- TEMP. COOLING END CYCLE
- BUZZER
Refer to dryer user manual for program
creation / modification.
Anyway, entering in each paramether
pressing “ENTER” it can be modified.
To exit from this menu, press “STOP”
until the display shows “SELECTR
PROGRAM”.
8. BOARD RESET
To set the factory orginal value press at
the same time the keys
“+” and “-“. The
display is showing “PASSWORD”.
Press “ENTER” and digit “712”
Wait for some seconds until the message
“OK” will be displayed. Switch off the
board and than switch it on again.
9. “COIN OP” PROGRAM
The control board can be configured to
work in coin op version dryer.
Digit the password “6776” and later use
