IMER U.S.A. Inc.
8
®
WHEELMAN
ASSEMBLY
3
4
Next slide the drum onto the driveshaft #3,make
sure the notched area on the drum #4 lines up
with the shear pin.Then anchor the drum in
place with the T-Bolt #1 and T-Bolt #2 washer.
Push the drum up onto the driveshaft while at
the same time tightening the T-Bolt by hand.
Once the T-Bolt is tightened as much as
possible by hand,give it a whack or two with a
hammer-no more,no less.
Anchor the mixing paddles #2,with the large
flat head screws #1 and nuts #3 provided.
It is best to place the flat head of the screw on
the outside of the drum.
This keeps the external contour of the drum
smoother and less likely to catch or pinch
objects as the drum is rotating.
1
3
2
1
2
4
3
DRUM
DRIVE
SHAFT
