3
3
3
3
3
V RANGE POTATO PEELING MACHINES
Pedestal Models
Pedestal Models
Pedestal Models
Pedestal Models
Pedestal Models
These machines must be fastened to the floor.
1
Loosely assemble the machine unit to the pedestal by placing the oval shaped register
around the bottom of the machine unit into the top of the pedestal assembly.
2
Place the whole unit into position and mark around its outside on the floor (note any
height adjustment to be made to pedestal).
3
Put the pedestal back in place on the floor in the mark previously made.
4
Down inside the pedestal the fixing holes will be visible. Mark these through onto the
floor, and fit rawlbolts or other suitable floor fixings.
5
Fasten the pedestal to the floor with these fixings and tighten up. Select height of
pedestal required and secure. Height adjustment to the discharge chute from the floor is
available as follows:
Min
2nd
3rd
4th
Max
VC7
725
790
840
890
940mm
VC14
745
810
860
910
960mm
6
Use the rubber plugs to close off the unused holes.
7
Finally, replace the machine unit into the pedestal and fit the three screws tightly.
Proceed with Supply Connection Instructions.
SUPPLY CONNECTION INSTRUCTIONS
SUPPLY CONNECTION INSTRUCTIONS
SUPPLY CONNECTION INSTRUCTIONS
SUPPLY CONNECTION INSTRUCTIONS
SUPPLY CONNECTION INSTRUCTIONS
ELECTRICITY SUPPLY CONNECTION
ELECTRICITY SUPPLY CONNECTION
ELECTRICITY SUPPLY CONNECTION
ELECTRICITY SUPPLY CONNECTION
ELECTRICITY SUPPLY CONNECTION
Examine the rating plate attached to the machine to ensure that the characteristics shown are
correct for the supply available.
The control switch should be as near to the machine as the length of cable will allow. If this is
not possible, provided the extra length is not considerable, the cable can be replaced with a
longer piece of the same specification. Unless a jointing box is used DO NOT
DO NOT
DO NOT
DO NOT
DO NOT splice cable
together but replace with a complete new length back to the terminal box.
The control should be a motor starter but a 13 amp fused or 15 amp round pin switch socket
will serve. These must be 3 pin and EARTHED and on no account must a 5 amp lighting point
be used. Fuse with a 13 amp fuse to BS1363. Three phase machines should be connected to
a 15 amp three pole isolator fused at 5 amps.
When using a motor starter, follow the instructions supplied with it.
New mains supply run to the machine should always be undertaken by a reputable and
competent electrician. The IEE Codes of Practice must be observed.
W
W
W
W
W
ARNING
ARNING
ARNING
ARNING
ARNING
: T
: T
: T
: T
: T
HIS
HIS
HIS
HIS
HIS
APPLIANCE
APPLIANCE
APPLIANCE
APPLIANCE
APPLIANCE
MUST
MUST
MUST
MUST
MUST
BE
BE
BE
BE
BE
EARTHED
EARTHED
EARTHED
EARTHED
EARTHED
