INTERNATIONAL MACHIINE CONCEPTS
4
capacitors.
5.5 The requirements of induction machine sealing for selection of the sensing
membrane and the bottle cap:
(1) The material of used sensing membrane must be the same as that
of the sealed bottle.
(2) The optimum thickness range of foil on the sensing membrane is
between 0.012 and 0.03mm. For the sensing membrane with the
aluminum foil being less than 0.012mm in thickness, sealing
speed and quality are not guaranteed.
(3) The vacuum aluminum plating composite membrane similar to
aluminum foil induction membrane must not used.
(4) When using the sensing membrane without paper pad, the bottle
mouth and cap must be smooth and without deformation.
(5) It is not applicable to non-threaded object sealing using the
cover, as the cover can not completely press the sensing
membrane flatly and tightly, resulting in the phenomenon of
loose sealing closure.
6. Operation steps
6.1 Turn on the power switch (look at whether the voltage is normal), start the cooling fan,
delay for 5 seconds and make the main circuit work, press the seal switch to make the seal
work.
Note: it is prohibited to continuously and rapidly switch on and off the power
supply and seal switch! Wait for at least 5 seconds after turning off the power switch,
then re-open the power supply, or else, it would be easy to damage the equipment.
6.2 Adjust the sensing head to make it higher than the sealed object by 1 to 3mm. Place the
sealed objects on both ends of the sensor head, and check whether the sensor head and the
conveyor belt are parallel. If not parallel, adjust the pillar below the conveyor belt to make
it parallel.
6.3 According to the bottle diameter, select the sealing range of the sensor head.
6.4 Press down the sealing switch, and try sealing. If the sealing is not firm, reduce
the speed of conveyor belt. If the sealing membrane is burnt, increase
the conveyor speed or increase the sensor head. After the requirements
on sealing quality are met, continuous automatic sealing operation can
start.
6.5 To ensure that the seal will be always in the best working condition,
