6
FROSTAR FR60 and FR90
OPERATION
1. Plug in and switch on at the mains.
2. Switch the unit on using the On/Off, which is located at the front left-hand side
of the plinth.
3. Check that the light is working.
4. Run the unit empty, and check that cold air is being circulated within the
cabinet.
5. Load the cabinet with glasses by placing them on the wire shelves, ensuring
that the glasses are standing in an upright position. Do not obstruct the air
vents inside the cabinet.
6. All cabinets have an electronic off-cycle defrost controller that de-ices the
evaporator for a maximum of 30 minutes every 4 hours using electric heaters.
This evaporates the condensate water without the need for a drainage
connection.
7. The controller also ensures that the cabinet temperature is maintained at -18°C
±2°C between automatic defrost cycles. Note that this temperature is adjustable
(refer to above section
“CHANGING THE CONTROLLER SET POINT”.
8. When the unit is not going to be used for several weeks, run it for 24 hours after
emptying it, to ensure that all condensate water evaporates.
MAKING THE BEST USE OF THE CABINETS
Do not overload the cabinet.
There should be a gap of at least 40mm above the
merchandise on the top shelf, and merchandise should be spaced to allow the
circulation of cooled air throughout the cabinet. Do not load the cabinet with boxed
goods as this prevents air circulation.
Do not place hot or warm goods in the cabinet. Only goods at room temperature or
less should be placed in the unit otherwise performance will be affected.
Do not run unit with the lid open, as this will cause the evaporator to ice up
preventing the unit from working efficiently.
Ensure that both the front grille cover attached to the plinth, and the air vents inside
the cabinet are always unobstructed.
Clean lid and the surfaces, and occasionally remove all merchandise and clean
interior surfaces with a damp soft cloth.
DO NOT USE CLEANING MATERIALS
CONTAINING ABRASIVES OR BLEACHES.
In the case of heavy soiling use a
mild liquid detergent. The unit can be washed on the inside using bicarbonate of
soda to remove stale smells.
