IMC EASYJET E400P, Руководство пользователя

Страница: 30 / 36

The Manual of Ink-jet Printer
29
Frequent Troubles Elimination
Ø 3. System troubles ：
Trouble Reason Solution
The character is entire,
however is illegible and in
shadow The distance from print head to
product surface is too far; or
running in fast airflow condition.
Shorten the distance
The character is un-entire
The surface of print head &
nozzle leaves impurity, or the
inks were dry. Purge the print head by cleaner;
Squeeze the ink-cartridge until the inks
spill out.
Print head system is damaged. Replace print head system
Ink leaks for long time(It’s a
normal situation that after
squeeze ink cartridge, ink
will spill out for seconds)
Print head stand is not in
horizontal.
Adjust the stand in horizontal.
Print head installation is not
according to user manual.
Inquire manufacturer to re-install.
Some parts connection are
loose.
tighten or replace the parts.
character is shortage As above As above
After squeezed the ink
cartridge, it can get a good
result, however the result
will goes bad in a very
short time, especially the
top of character. Injector or filter was blocked Purge or replace the blocked parts.
Some parts of ink system was
loose.(ink hose, ink cartridge,
injector etc.)
Tighten or replace the blocked parts.
No dot can spill out
Print head cap is not open, or
did not purge print head gap. Open print head cap, purge print head
gap and squeeze ink cartridge.
Print function is not start up Press PRINT key
The indicator light of sensor
shows dark or bright all the
time.
l Adjust installed distance.
l Check up if the surface has inks
l Check up the cable plug.
l Replace the photoelectric sensor
Printing parameters are
incorrect
l Turn down speed rate.
l Reduce print delay
l
Shorten the files space.
l When encoder is not connected,
cancel the encoder selection.
No inks leak when squeezed
ink cartridge; injector, filter or
print head were blocked.
Purge or replace blocked part.
Ink cartridge is too thick or
useless Replace a new ink cartridge and
squeeze it
Working condition temperature
is too low The working condition temp, shall
higher than
5 ℃