9
Configuring the McPC 10/100 (ISA Version)
Before installing, configure McPC 10/100 for desired features using the DIP Switch
located as shown below on the printed circuit board (PCB). The following illustration
shows the location of the DIP Switch as well as its default settings. Consult the chart
below for the function of each switch.
The table below shows the DIP Switch settings for McPC 10/100:
Feature
Switch #
Function
Default
LFD
5
Link Fault Detection (Available in Force modes only)
OFF
AN
6
Auto Negotiation Mode (Valid only when Force mode
is disabled)
ON
Force
7
Force Mode – Forces the converter to operate at 10 or
100 Mbps as determined by switch
8
OFF
10/100
8
Valid only when switch
7
is
ON.
When
ON
, the converter operates at 10 Mbps. When
OFF
, the converter operates at 100 Mpbs.
8
is only
valid in Force Mode, i.e. when switch
7
is
ON
OFF
NOTE
Switch #'s
1 – 4
are factory configured
– DO NOT CHANGE
