IMB MB2003B, Инструкция по эксплуатации

Страница: 17 / 23

13
6.4 Knife change
1) Remove the two fixing screws (1) in the figure above and take out the cutter device；
2) 2) Remove the upper cutter fixing screw ○
2
, remove the upper cutter, replace the new
cutter, install the fixing screw ○
2
and tighten it
3) Remove the two retaining screws ○
3
，Remove the lower cutter, replace the new cutter,
and install the fixing screw ○
3
without tightening;
4) Adjusting set bolt ○
4
，Make the upper and lower cutters in point contact state, and
then tighten the set screw ○
3
5) Install the cutter device back into the machine head, tighten the fixing screw, and
the cutter replacement is completed。
○
3
○
4
○
2
○
1