Platinum™ Predator II-GX 2RU
Chapter 4
Installation and Operation Manual
Using ZConfigurator
© 2014 Imagine Communications.
Proprietary and Confidential.
Edition E | Page 58
Audio Scales and Transitions
The default settings for audio meter scale type and transitions are set to AES with the yellow/red
transition at -11dB and the green/yellow transition at -33dB. These levels are sufficient for most
purposes, but you can change them.
They are configured on the System Setup Audio tab. See Audio Settings (on page 68) for details.
Global Alarm Settings
Global settings that affect such things as alarm trigger sensitivity and threshold delay are set in the
System Setup Alarms tab. These settings may also be left at their default settings when learning the
interface for the first time.
See Global Alarm Setting Configuration (see "Global Alarm Settings" on page 70) for details.
Complete Configuration
The following settings are configured on the
System Properties
dialog box in ZConfigurator. Before you
begin, make sure that you have connected the Predator
II
GX module to the PC that runs ZConfigurator
(see Connecting to Predator II GX for the First Time (on page 43)).
System Setup is not available unless you are connected to a multiviewer.
The following topics are discussed in this section:
Configuring DVI Output and Resolution (on page
UMD and Tally Configuration (on page 61)
Ross Switcher Setup (on page 62)
Platinum Router Setup (on page 63)
Communication Ports (on page 65)
GPI Mapping (on page 66)
Audio Settings (on page 68)
Global Alarm Setting Configuration (see "Global Alarm Settings" on page 70)
Enabling Alarms (on page 71)
Time Synchronisation (on page 74)
Managing Language Packs and Fonts (on page 75)
Using SNMP Agents (on page 78)
Checking and Optimizing Installed Cards (on page 79)
Setting System Properties (on page 81)
Copying Settings to Other Units (on page 84)
Setting Master GPI Output Options (on page 85)
Using Bitmap Images (on page 86)
Changing System Themes (on page 87)
