Selenio
TM
BNP User Guide, Release 3.7.1
211
- DVB-CA Configuration
Note:
If you have configured the BNP in a 1:1 redundancy environment, the Gateway IP Address for
Ethernet Port 2 must be configured.
2.
Click the
Apply Configuration
button to indicate confirmation of the settings displayed on the
screen.
Before using the settings, the BNP will prompt for a reboot. Additional information for performing
BNP reboots is provided in “Rebooting the System” on page 196.
Settings will take effect upon completion of the reboot.
Configuring GigE or ASI Port(s) for DVB-CA System
Use guidelines in this section to set port addresses, mirroring, and/or negotiation, as described in the
following topics:
•
“GigE Port Input and Output Interface Configuration,” next.
•
“ASI Port Input and Output Configuration” on page 212.
GigE Port Input and Output Interface Configuration
Use the
GigE Ports
tab page to manage the GigE ports for the BNP. Note that GigE port can be used
for simultaneous input and output.
Menu Path
Access via
BNP Element Manager
Configuration tab -> GigE Ports
tab page.
Figure 149. Configure GigE - DVB-CA
1.
Type the
IP Address, Subnet Mask, Gateway
, and
Auto-negotiation
information for the input
and output GigE port(s) that are to be used for encryption.
2.
Click
Apply Configuration
to save changes.
