1.
Make sure that the power cord is unplugged.
With the help of another person, carefully tip the tread-
mill onto its left side. Partially fold the Frame (59) so the
treadmill is more stable.
Do not fully fold the treadmill
until it is completely assembled.
Identify the Left Upright (29) and the Right Upright (30);
the indicated brackets on the Uprights overhang toward
the center of the treadmill. Make sure there are two U-
Nuts (122) (see the inset drawing) in the lower end of
each Upright. Feed the Wire Harness (74) into the bot-
tom of the Right Upright, and pull the Wire Harness out
of the hole in the top of the Right Upright. Note: There
may be a tie on the Wire Harness to help you pull it out
of the hole.
Attach the Right Upright (30) to the right side of the Base
(97) with two 2 1/2” Bolts (61) and two 5/16” Star
Washers (36).
Do not tighten the Bolts yet. Be careful
not to damage the Wire Harness (74). Attach the Left
Upright (29) to the left side of the Base in the same way.
Note: There is not a wire on the left side.
36
74
30
29
59
Brackets
61
97
1
1/4” Washer
(39)–4
1/4” Silver Star
Washer (77)–4
1” Tek Screw (80)–2
5/16” Star
Washer (36)–4
Extension Leg Bolt (96)–4
Silver Ground
Screw (103)–1
3/4” Screw (108)–10
4” Bolt (76)–4
2 1/2” Bolt (61)–4
Use the drawings below to identify the hardware used during assembly.
Note: If a part is not in the parts bag,
check to see if it has been preattached to one of the parts to be assembled.
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials except
for the packing materials around the brackets on the uprights (see step 1). Do not dispose of the packing
materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-perfor-
mance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or
the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on
top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver
and wire cutters .
1a
122
29, 30
61
36
6