Image Sensing Systems RTMS G4, Установка, эксплуатация, обслуживание и устранение неисправностей, Страница: 4 / 8

Next step is to calibrate the MVDS:

Click on Wizard Setup, let run until all lanes are detected/ once all lanes are
detected Wizard will close automatically (add 1 minute if needed)

Click Manual Settings

Click Zones

Number , and adjust lane direction as needed per screen instructions

Click OK

Click Exit once

Click Speed Calibration / enter speed limit for location of mvds

Click Start / let run until all lanes reach 100%/ Exit

Exit & Click calibration. Enter speed limit for the area in each lane shown
(set inner lanes a few mhp faster than outer lanes)

Click Start / let run till completed (add time if still needed)

Exit & Click Statistics , check box to note calibrated speeds, then Exit

Click Calibration again, choose Manual Settings , adjust lane speeds one at a
time using up and down arrows for lane change, and left and right arrows for
speed change

Exit & Click Statistics again / check box to show traffic for current speeds,
if speeds look good, then exit, If not, repeat steps above.

Click Manual Settings again

Click Data, change from Normal to Polled status (allows Sunguide to read)

Click Exit, then Exit Program, to complete process