LE6 USB-INTERFACE V1.0
INTRODUCTION
The Image Engineering LE6 USB-Interface is an hardware interface for the LE6 integration sphere.
It allows to measure and control the illumination level automatically by using a PC.
INSTALLATION GUIDE
1.
Installing Hardware drivers
Run
setup.exe
in the
Hardware Driver
folder and follow the instructions.
2.
Connecting Hardware
Connect the USB-Interface to your PC, two more Hardware drivers will be installed automatically.
3.
To run the software,
Matlab Component Runtime
is required
Run
MCRInstaller.exe
in the
MCRInstaller
folder and follow the instructions.
This will install the Matlab Component Runtime on your system, if necessary.
4.
Copying program files
Copy the folder
USB-Interface Software
on to your harddisk.
SETTING UP THE HARDWARE AND CONNECTING TO LE6
Plug the grey control cable into the 8-pole connector and the black measuring cable into the BNC connector.
Turn the rotary switch to the left stop position (position
A
or
USB operation
).
Switch on the power switch and the luxmeter switch.
www.image-engineering.de 2
