Assembly
Procedure
1.
Remove the Stand and Monitor box from its shipping
pallet.
2.
Open the monitor box and place the open end on the
floor (flaps open) and lift the box off of the monitor.
3.
Rotate the monitor and place it on its end and remove
both of the Foam Protectors.
4.
Place the monitor face down onto the Monitor Box as
shown on the right.
5.
Lock two of the front casters of the monitor stand, grab
hold of the top of the stand and tilt it over, walking with
it until it is horizontal to the floor with the handle side
facing down. Remove the rear cover of the monitor
(thumb screws) to access the monitors Input manifold.
6.
Connect input cables into their respective connection
locations. The left C Arm input (green tape) should
always be applied to input No. 1.
NOTE: The Displayport to HDMI adaptor cable that comes
with the ilex 32 4K cannot be used to connect the HDMI cable
to the monitor’s
Displayport Port. It can only be used to
connect the Displayport Port on the C Arm to the HDMI cable.
Monitor Connection Panel
Cover Screws
Confidential, for IDI Customer and Representatives
only
Page 3
Monitor Mount
Tools
•
Metric Allen Hex Key (provided).
•
Medium Cross/Philips Head Screwdriver.
L280-0948 Rev. A
