Instruction Manual MX-500N / MV-500NII Series
8
Manual No.
MXV50801E
Features
Overview (Page 5)
Limit knobs
Upper / Lower travel limits are
… by those knobs. Turning left
to loosen. Tighten after sliding them up or down to any
position.
Crosshead
Goes up or down with force gauge.
Force gauge mount
Mount the force gauge here. There are certain holes suitable
for Imada brand force gauges.
Table
Put a sample here or fix a fixture with GF-1 grip mount.
Rear view (Page 6)
Inlet
Plug power cord (included)
Fuse case
A fuse is in this case
I/O Connector
MX series only
Connect certain force gauge here to use
“Force control
mode
” through an optional cable CB-501
EN-00 Connector
MX/MV-E series only
Connect a speed / Length meter EN-00 here
Operation panel (Page 7)
Emergency button
Force to stop the test stand by pressing this button for
emergency situation. To release the button, turn it left.
For MX series, you must return the test stand power on to
use it again.
Power switch
Turn on/off the power of the test stand
Speed volume
Adjust travel speed of the crosshead in no-step.
FS volume
Adjust travel speed when you select
“Fix speed (FS)” mode.
Seal this hole if you won
’t change speed.
FS button
Enable/Disable
“Fix speed” mode
Mode button
Select modes
Up/Down buttons
Indicate test stand movement
LEDs
Display current mode and movement