ILVE UHF40, Инструкция пользователя, Установка, Обслуживание

Страница: 14 / 28

14
GAS COOKTOP INSTALLATION
Remove the cooktop, gas pressure regulator, burner grates and burner caps from the shipping package. Lower
the cooktop into the countertop cut-out opening. Center the cooktop in the opening and check that the front edge
of cooktop is parallel to the front edge of the countertop. Check that all required clearances are met. Remove the
cooktop from the counter-top opening.
IMPORTANT NOTE: When repositioning the cooktop in the countertop opening, lift the entire cooktop up from the
opening to prevent scratching the countertop. Apply the foam strip, included in the hardware package, to the under
side of the cooktop frame. Refer to the illustration below.
Reinsert the cooktop into the countertop opening. Lift the entire cooktop to make adjustments. Attach the brackets
to the bottom of the unit. Insert the clamping screws into the brackets.Use a screw-driver to tighten the clamping
screws against the underside of the countertop. Refer to the illustration below. Do not overtighten screws.
IMPORTANT NOTE: Do not seal the cooktop to the countertop. It must be removed if service is necessary.
GAS PRESSURE REGULATOR Install the gas pressure regulator with the arrow on the regulator pointing up toward
the unit and in a position where you can reach the access cap.
IMPORTANT NOTE: All connections must be wrench-tight-ened. Do not make connections to the regulator too tight,
as this may crack the regulator and causea gasleak. Do not allow the regulator to turn on the pipe when tightening
fi ttings.